Water in Blender. The end to it?!
I bought the blender just yesterday. How long will it take before I can plug it in?
have you ever face the same thing before?
Answers:
Best Answer - Chosen by Voters
Clean with a damp cloth as well as you can...let the blender dry...my blender motor is protected from spills..so if yours is then you should be alright...
Good luck...
rinse as much milk off the blender as possible. Wait about a week for the water to dry, oil in the little hole under the jar. Just a couple drops of good machine oil like 3-in-one. Buzz the blender without the jar on it, then make sure the bottom of the jar is screwed on tight before putting the thing away. Saves lots of sleepy messes. And yes, I have done that, but wasn't because I was sleepy, just in a hurry and didn't take time to check that who ever washed dishes did things my way.
Most of them are reasonably well protected as your wee spill is not the first one and have been made for decades.
Just give it a good wipe down and use a bit of common sense on where the milk would have gone.
If you are in doubt leave out in the sun or in a warm place for a few hours.
I spill stuff all the time. Blenders are intended for liquids. So, blender casings are tight.
Wipe it off with a damp rag and it should be ready to use immediately