How do i cook rice?!


Question:

How do i cook rice?

ok when i make rice they do not get seperated how can i do that?


Answers:

Cooking rice by the absorption method is simple and reliable
Combine the rice and water and bring to a boil. Use 1-1/2 to 2 cups of water per cup of rice. If adding salt or fat, swirl the pan to mix them; rough stirring could break the rice. I grew up in a household that only boiled rice and only basmati at that. We'd tip some rice into a large pot of boiling water, adjust the heat to keep the rice just dancing to the surface, and check it now and again by taking a bite. When the rice was resilient without a trace of central hardness, the water got poured off and saved for soup. To make the rice dry and fluffy, we'd tip it back into its pan, cover it, and cook it further over very low heat.

I now prefer the absorption method. In this more streamlined process, the rice is cooked in a measured amount of water so that by the time the rice is cooked, all the water has been absorbed. As the water level drops, trapped steam finishes the cooking.

For every cup of rice, use 1-1/2 to 2 cups of water (less if the rice is washed first). You'll need to experiment a little to find the amount you like best, but in general, use the larger amount for long-grain rice, the lesser for medium and short. Keep in mind that more water gives you softer, stickier rice—great for stir-fries. Less water will keep the grains more separate and result in firmer rice, a good style for rice salads.

Use a sturdy pot with a tight-fitting lid
Lower the heat to a simmer—bubbles gently bursting on the surface—and cover. Let white rice cook for 12 minutes. Then let the rice rest off the burner, covered, for at least 5 minutes and as long as half an hour. Fluff the rice gently with a fork or chopstick. Gentle handling will keep the individual grains from breaking up into mush. You want a pot with a heavy base for the most even cooking, and one that's big enough to provide plenty of room above the rice for steam. A tight lid keeps the steam in. If your lid fits loosely, put a clean kitchen cloth between the lid and the pot. (Be sure to fold it over onto the pot so it doesn't burn.) The cloth also absorbs the water that would normally condense on the inside of the lid and fall back down into the rice, so this is also a good trick to get drier, fluffier rice.

A bit of butter or olive oil will also help keep the grains from sticking together, while a little salt adds flavor.

Once all the ingredients are combined, cover the rice and let it simmer. On an electric stove, use two burners: bring the rice to a boil on a hot burner and then immediately slide it to a burner set on low to continue cooking at a slow simmer.

After about 12 minutes, the liquid should be absorbed, and the rice still al dente. If you served the rice now, you'd find the top layer drier and fluffier than the bottom, which can be very moist and fragile. Here's where you need patience. Let the rice sit off the heat, undisturbed with the lid on, for at least 5 minutes and for as long as 30. This results in a uniform texture, with the bottom layers as fluffy as the top. That a pot of rice actually improves with a rest also gives you more flexibility for cooking the rest of the meal.




The consumer Foods information on foodaq.com is for informational purposes only and is not a substitute for medical advice or treatment for any medical conditions.
The answer content post by the user, if contains the copyright content please contact us, we will immediately remove it.
Copyright © 2007 FoodAQ - Terms of Use - Contact us - Privacy Policy

Food's Q&A Resources