How i do this how make a fountain out of plastic bottles ?!
How i do this how make a fountain out of plastic bottles ?
Answers:
YOU NEED A RECIRCULATING PUMP(WHICH YOU CAN BUY AT ANY HARWARE STORE,SEVERAL BOTTLES KNIFE SCISSORS AND A BIG BOWL FOR POOL.SET RECIRCULATING PUMP AT BOTTOM UNDER WATER IN BIG BOWL.CUT EACH BOTTLE ABOUT 8 INCHES FROM TOP(DISCARD THE BOTTOMS)TURN THE BOTTLES UPSIDE DOWN INTO EACH OTHER AND HOT GLUE THE TOPS TO THE INSIDE OF EACH OF THE OTHER BOTTLES(LET HARDEN.RUN A RUBBER HOSE FROM RECIRCULATING PUMP UP THROUGH ALL THE BOTTLES TILL IT STICKS UP ABOVE THE OPENING OF THE TOP MOST BOTTLE AND TURN PUMP ON. WATER WILL FILL EACH BOTTLE TILL IT RUNS OVER THE EDGES TILL IT FILLS UP ALL THEN BACK INTO BIG BOWL AT BOTTOM,THEN START OVER. GOOD LUCK
EMAIL ME AT SEANBULLOCH@MSN.COM IF YOU NEED ME TO DRAW YOU A DIAGRAM.I WILL SCAN IT AND SEND IT BACK TO YOU!
DONT USE BEER BOTTLES...USE 2 OR 3 LITTER COKE BOTTLES...WORKS BETTER
what the..........
i had the same problem but it was really hard to find plastic beer bottles. once you got those you just drink the beer you just need tape and scissors and the garden hose. viola.
the second answer is probably the right way, but if you put a caffeine pill in soda it will be like a fountain for a little bit.
u should make a tiny hole in a water bottle and squeeze it ur fountain is ready ha ha ha