How can i completely drain a can without opening or pricking a hole in it?!


Question: How can i completely drain a can without opening or pricking a hole in it!?
A coke can, sprite can etc!. No holes, and no opening it!.Www@FoodAQ@Com


Answers:
boil water and than place the can in the water after about 20 seconds remove it and put it in the freezer!. The contents of the can will condense and cause a slow dissipation to occur!. If you repeat this over and over again 1000s of times you will eventually have an empty can!. This is why you see old cans unopen but empty!. They have gone through this process of cold to warm for many years!. We can speed up the process with the above!. Www@FoodAQ@Com

Melt it!. You wouldn't be poking any holes in it, it'd just all melt into a nasty, aluminum-soda mixture!. Www@FoodAQ@Com

open it, drain it, weld it closed againWww@FoodAQ@Com

ImpossibleWww@FoodAQ@Com

LEAVE IT IN A WARM PLACE AND IT WILL EAT A HOLE IN THE CAN BY ITSELFWww@FoodAQ@Com

Dumb question!.Www@FoodAQ@Com

put it in the freezer! lolWww@FoodAQ@Com

blow torchWww@FoodAQ@Com

cut it in halfWww@FoodAQ@Com

melt itWww@FoodAQ@Com





The consumer Foods information on foodaq.com is for informational purposes only and is not a substitute for medical advice or treatment for any medical conditions.
The answer content post by the user, if contains the copyright content please contact us, we will immediately remove it.
Copyright © 2007 FoodAQ - Terms of Use - Contact us - Privacy Policy

Food's Q&A Resources