How to use rabbit cork remover on wine bottle?!
open the lever all the way
place the 2 side clamps around the mouth of the bottle and hold tightly closed with 1 hand.
with your other hand, depress the lever all the way
now pull the lever all the way open. this will remove the cork
release the bottle with the clamping arms and depress the lever so the cork is inbetween the clamps
clamp the arms around the cork
open the lever all the way to remoce the cork from the screw
ta-daa!
what a cool invention, huh?
Answers: set the bottle on the table
open the lever all the way
place the 2 side clamps around the mouth of the bottle and hold tightly closed with 1 hand.
with your other hand, depress the lever all the way
now pull the lever all the way open. this will remove the cork
release the bottle with the clamping arms and depress the lever so the cork is inbetween the clamps
clamp the arms around the cork
open the lever all the way to remoce the cork from the screw
ta-daa!
what a cool invention, huh?
You have got to put the cork screwer on the cork, squeeze the ears together, then pull tale down. Then open and close ears, and pull tale up, this should remove the cork nicely.
Clamp the Rabbit on the top of the bottle with the lever pointed down toward the floor, open and relaxed. While squeezing the "legs" together around the top of the bottle, lift the lever up and fold it over the top so that the corkscrew plunges into the cork all the way. Then, still holding onto the legs tightly, pull the lever all the way back to its original position. The cork is now out of the wine. To remove the cork from the Rabbit, remove the device from the top of the bottle, fold the lever forward again, then back to the original position. Now the cork is on the counter. Voila!
First if the cork of the bottle is covered with foil, cut it off to expose the cork.
There are 3 levers. 2 that are side by side and only move closer to each other and away from each other. The 3rd lever moves the actual cork screw part (the curly piece with a point on the end). Hold the rabbit with the 2 side by side levers parallel to the floor and the 3rd lever parallel to the ceiling. If the cork screw part is in between the 2 side by side levers move the 3rd lever up until the cork screw is no longer in between the 2 side by side levers. Separate the 2 side by side levers and place them over the tip of the neck of the bottle. Now close the 2 side by side levers to where the tip of the neck of the bottle is in between the 2 side by side levers. If you have done everything right so far the point of the cork screw will be just above the cork on the bottle. Pull the 3rd lever down once and then back up once. Let go of the tip of the neck of the bottle and it will now be open.
To get the cork out of the rabbit:
Hold the rabbit in the same position but without the tip of the neck of bottle in the device. Move the 3rd lever down. The end of the cork not attached to the cork screw will be below the 2 side by side levers. Use this end of the cork to unscrew it from the cork screw.